Elmo ExtrIQ line Guia de Instalação descarregar pdf (Página 8)

Hornet and Bee Installation Guide Safety Information

MAN-HRBEIG (Ver. 1.3)

www.elmomc.com

1.1. Warnings

• To avoid electric arcing and hazards to personnel and electrical contacts, never

connect/disconnect the servo drive while the power source is on.

• Power cables can carry a high voltage, even when the motor is not in motion. Disconnect

the Hornet and Bee from all voltage sources before it is opened for servicing.

• The Hornet and Bee servo drives contain grounding conduits for electric current protection.

Any disruption to these conduits may cause the instrument to become hot (live) and

dangerous.

• After shutting off the power and removing the power source from your equipment, wait at

least 1 minute before touching or disconnecting parts of the equipment that are normally

loaded with electrical charges (such as capacitors or contacts). Measuring the electrical

contact points with a meter, before touching the equipment, is recommended.

• Cleaning after soldering. To avoid damage to the product’s acrylic coating, the Hornet and

Bee must not be cleaned after soldering with soluble solvents or water-based cleaners. For

further details see:

www.elmomc.com/applications/article/Soldering-and-Cleaning_Application-Note.pdf

1.2. Cautions

• The Hornet and Bee servo drives contain hot surfaces and electrically-charged components

during operation.

• The maximum DC power supply connected to the instrument must comply with the

parameters outlined in this guide.

• When connecting the Hornet and Bee to an approved 12 to 95 VDC auxiliary power supply,

connect it through a line that is separated from hazardous live voltages using reinforced or

double insulation in accordance with approved safety standards.

• Before switching on the Hornet and Bee, verify that all safety precautions have been

observed and that the installation procedures in this manual have been followed.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 72 73

Sem comentários

Elmo ExtrIQ line Guia de Instalação Página 8